Silvercrest H14271, Operation And Safety Notes, Page: 31 / 43

31 GB/MT
Safety Instructions / Getting started
J
Leaked or damaged batteries can
cause chemical burns if they come into
contact with the skin; in such
cases you must wear suitable protective gloves.
J
Avoid contact with the skin, eyes and mucous
membranes if fluid has leaked from the battery.
In the event of contact with battery acid, rinse
the affected area with plenty of clean water
and consult a doctor immediately.
J
Remove light dirt from the battery and product
contacts with a dry, non-fluffing cloth before
inserting the batteries.
J
Remove the batteries from the product if it is
not in use for any length of time.
J
Make sure that the polarity is correct when you in-
sert the batteries. This is indicated in the battery
compartment. The batteries can otherwise explode.
J
Insert the batteries with care. The product can
otherwise be damaged.
J
Please do not dispose of used batteries in your
household waste but take them to a designated
collection depot for special waste.
Q
Getting started
1. Open the battery compartment
8
on the back
of the product by pushing the clip of the bat-
tery compartment cover
9
towards the bat-
tery compartment
8
and lift the cover off.
2. Remove the isolating strip. This is located be-
tween the batteries and the battery compart-
ment
8
.
3. Replace the battery compartment cover
9
on
the battery compartment
8
. Make sure that
the two extensions on the battery compartment
cover
9 engage in the two openings in the
battery compartment
8
. Press the battery
compartment cover
9
onto the battery com-
partment
8
until it noticeably and audibly
clicks into place.
Q
replacing batteries
1. Open the battery compartment
8
as described
above.
2. Remove the used batteries from the battery
compartment
8
by carefully pushing the con-
tact
10
upwards a little. Make sure that you do
not exert too much pressure on the contact
10
.
It may otherwise be damaged.
Remove the batteries from the battery compart-
ment
8
.
3. Insert the new batteries. Make sure that the polari-
ty is correct. The “+“ must be pointing upwards.
Press the contact
10
down again carefully so
that the batteries are held in the battery com-
partment
8
.
4. Close the battery compartment
8
as described
above.
Q
Weighing
nOtE:
The kitchen scale 2 always starts at
0 g/0.0 oz when you switch it on. If you place the
weighing bowl
1
on the kitchen scale
2
before
switching it on, 0 g/0.0 oz “Zero“ is displayed.
However, if you place the weighing bowl
1
on
the kitchen scale
2
after you have switched it on,
the scale will indicate the weight of the weighing
bowl
1
. Press the zero button
7
to reset the dis-
play to 0 g/ 0.0 oz.
j
Place the weighing bowl
1
on the kitchen
scale
2
.
j
Press the ON/OFF button
3
to switch the
kitchen scale
2
on.
j
Select the unit of weight by pressing the Unit
button
6
. You can choose between “g/kg“
and “oz/lb“.
j
Place the food you wish to weigh in the bowl.
j
The LCD readout 5 indicates the weight of the
food in the selected unit of weight.
nOtE: The scale operates almost exactly the
same way without the bowl
1
. To operate without
bowl, simply follow & repeat the same steps as
above except starting without the bowl
1
.