Silvercrest 75359, User Manual And Service Information

Page: 77 / 102

SilverCrest graphics tablet SGT 10.6 A2
English - 75

Only use a battery of the same type and the same charging capacity. Always ensure correct
polarity of the battery. Remove the battery if you will not be using the device for a prolonged
period of time, as it can leak. Contact with the skin will cause chemical burns. For this reason it
is absolutely essential to remove leaking batteries with acid-resistant protective gloves.

Never try to recharge batteries and never throw them into an open fire (risk of explosion).

Remember to protect the environment. Used batteries should not be disposed of in domestic
waste. They must be taken to a collection point for old batteries.
Prior to use
The graphics tablet helps you to edit graphics and photos. You can also use the graphics tablet to
create drawings and write notes on your computer in the same way as you would using a sheet of
paper. Proceed as follows to start using your graphics tablet quickly and easily.
Step 1: Inserting the battery into the digital pen
To insert batteries proceed as follows:
1. Remove the cap.
2. Push the cover upwards slightly and lift it
off.
Do not push the cover too far
upwards, as the tabs at the front could
otherwise break off.
3. Remove the film from the supplied battery
and insert the battery. The positive pole (+)
must always point towards the open end of
the pen.
Always ensure correct polarity of the
battery!
4. Place the tabs of the cover into the front of
the bottom section and carefully push
down until the cover snaps into place on
the bottom section. Do not use any force.
5. Replace the pen cap.