SHSS 18 B1
■
8
│
GB
│
IE
Connecting/removing the hand
element to/from the handle rod
Fig. 2
Fig. 3
1) To connect the hand element
3
to the handle
rod
0
, push the tip of the hand element
3
into the opening in the hand element recess
e
.
2) Then press the grip
1
of the hand element
3
into the handle rod
0
until the hand element
3
clicks firmly into place (Fig. 2).
3) To remove the hand element
3
from the
handle rod
0
, press both release buttons
w
.
4) Then pull the hand element
3
upwards and
forwards out of the hand element recess
e
(Fig. 3).
Operation
ATTENTION! PROPERTY DAMAGE!
►
The suction opening must always be open
and may not be blocked. Blockages lead to
overheating and damage to the motor.
►
Do not vacuum shag pile carpet with the floor
nozzle. The rotary brush
r
can get caught
in the carpet and jam!
NOTE
►
Make sure that the HEPA filter
5
and the
coarse filter
6
are always inserted before
using the appliance.
►
As soon as the suction power of the appliance
begins to diminish noticeably and the charge
indicator lamp
2
flashes blue, connect the
appliance to the mains adapter
u
.
Using the hand element with the
handle rod
1) Insert the hand element
3
into the hand
element recess
e
as described in the section
Assembly/disassembly
.
2) Switch on the appliance using the On/Off
switch
8
. The charge indicator lamp
2
lights up blue, the LED light
t
on the floor
nozzle lights up and the rotary brush
r
starts rotating.
NOTE
►
Press the ECO button
9
to switch to the
energy-saving ECO mode. The appliance
now uses a lower suction power but can run
for longer.
Press the ECO button
9
again to work with
full suction power.
3) Guide the floor nozzle over the area to be
vacuumed. Hold the handle rod
0
so that the
floor nozzle moves smoothly over the floor.
4) Press the On/Off switch
8
when you have
finished vacuuming. The rotary brush
r
stops
and the charge indicator lamp
2
as well as
the LED light
t
switch off.
