Silvercrest 353667 2010, Operating Instructions Manual

Page: 20 / 272

GB│IE │
17 ■ SHBS 500 D4
Cutting contours and beard trimming
WARNING! RISK OF INJURY!
► The cutting blade of the shaving head
1
is sharp. Handle it careful-
ly and never touch the cutting blade with your fingers.
NOTE
► Only cut dry hair with the appliance.
► Depending on the cutting angle, the cutting length can vary from the
setting on the comb attachment
0
/
q
.
► Make sure that the comb attachment
0
/
q
sits firmly on the shav-
ing head
1
after adjustment.
♦ Set the cutting length to the desired hair length on the comb attachment
0
/
q
. To do this, press the button on the back of the comb attachment
0
/
q
and push the comb attachment
0
/
q
upwards or downwards
(see fig. 3). You can read the cutting lengths via the markings on the
comb attachment
0
/
q
(see fig. 4). Now trim your beard in stages.
NOTE
► Press the upper side of the button, when you push the comb attachment
0
/
q
upwards or downwards (see fig. 5). This makes it easier to
release the comb attachment
0
/
q
from the catch and move it.
♦ You can use the appliance without the comb attachment
0
/
q
(i.e.
with only the shaving head
1
) to cut your hair very short or to cut your
beard and contours. In this way, you can cut the hair evenly down to
1–2 mm.