GB
│
IE
│
NI
│
CY
│
9
■
SV 125 C3
3) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring
5
. The bag should
be inserted no further than the rear limiters
6
and must lie between the front
limiters
7
. If the bag lies over one or both of the two limiters
6
/
7
, then the
bag cannot be correctly welded.
NOTE
►
The bag opening must lie fl at on the welding wire
4
. Otherwise the weld-
ing does not work properly.
4) Close the appliance lid
1
. The press seal
q
presses the bag onto the welding
wire
4
, to create a smooth seam. Ensure that both corners of the appliance
lid
1
click closed. If necessary, press them down once again on the markings
and
so that the appliance lid
1
clicks into place and locks shut.
5) Press the button
r
. The control lamp
r
lights up. As soon as the sealing
process is completed, the control lamp
r
fl ashes briefl y and then goes out.
NOTE
►
You can halt the sealing process at any time by pressing the
button
r
again. The control lamp
r
fl ashes and then goes out.
IB_346881_SV125C3_LB6-.indb 9
15.05.2020 14:17:59