GB
│
IE
│
31
■
SSM 600 B2
Cleaning
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
►
Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block
6
in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
►
Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
►
Never disassemble the cutting blades
4
and never reach into the blender
3
.
The cutting blades
4
are extremely sharp!
CAUTION! PROPERTY DAMAGE!
►
Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
■
To prevent injuring yourself on the cutting blades
4
, clean the blender
3
only
with a long-handled washing-up brush.
■
Clean the measuring cap
1
and the lid
2
in mild soap solution. Ensure that
the rubber seal
9
is correctly fitted before using the lid
2
again.
NOTE
You can also clean the lid
2
, the measuring cap
1
and the
blender
3
with the cutting blade
4
in your dishwasher.
■
If you clean the blender directly after use, you can often achieve a
satisfactory and hygienic level of cleaning by doing the following:
Fill the blender
3
with 750 ml of water and add a few drops of mild
detergent. Close the lid
2
and fit the blender
3
onto the motor block
6
.
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades
4
churn through the water
at full speed.
Afterwards, rinse out the blender
3
with lots of clean water to ensure that
all detergent residues have been removed.
IB_339532_SSM600B2_LB8.indb 31
11.02.2020 16:19:44
Summary of Contents for 339532 1910
Page 3: ......
