Silvercrest 339531 1910, Operating Instructions Manual

Page: 21 / 82

19
GB
or place it on an even surface to be
able to read the water level display
3
correctly.
4. Close the lid 9 , by pressing it down-
wards.
5. Place the kettle on the device base 4 .
6. Insert the mains plug 5 into a readily
accessible earthed wall socket whose
voltage matches the voltage stated on
the rating plate.
7. Press the on/off switch 6 down, until it
lights up and locks into place.
8. The device automatically switches off as
soon as the water starts to boil, or when
you remove the kettle
2 from the device
base 4 .
9. Disconnect the mains plug 5 from the
wall socket.
10.Remove the kettle 2 from the device
base 4 and pour the water out.
8. Cleaning
DANGER! Risk of electric
shock!
~
Pull the mains plug 5 out of the wall
socket before you clean the kettle 2 .
~
The kettle 2 , the device base 4 , the pow-
er cable and the mains plug 5 must not
be immersed in water or other liquids.
DANGER! Risk of injury
through scalding!
~
The kettle 2 becomes very hot during op-
eration. Allow it to cool down before
cleaning.
WARNING! Risk of material damage!
~
Do not use any astringent or abrasive
cleaning agents.
Cleaning the kettle
1. Disconnect the mains plug 5 from the
wall socket.
2. Wipe the kettle 2 , the device base 4
and the power cable 5 with a damp
cloth if necessary. Dry with a dry cloth.
3. Allow all parts to dry completely before
you put them away or use the device
again.
Cleaning the limescale filter
1. Open the lid 9 .
2. Press the limescale filter 1 down and in-
wards.
3. Pull the limescale filter 1 off upwards
from the kettle 2 .
4. Clean the limescale filter 1 with a moist
dishcloth under running water.
5. Place the limescale filter 1 into the in-
tended recess in the kettle 2 and press it
down and outwards.
6. Release the downward pressure so that
the limescale filter 1 will lock in place at
the top in the recess.
Descaling
After some time, the boiling process will re-
sult in limescale being deposited in parts of
the kettle (depending on the hardness of the
water used). You should remove this at regu-
lar intervals, because otherwise the power
consumption of the device will increase.
1. Press the limescale filter
1 down and in-
wards.
2. Pull the limescale filter 1 off upwards
from the kettle 2 . If there is limescale
residue in the limescale filter 1 , place it
in the kettle when descaling.
3. Fill the limescale remover into the
kettle 2 . Use a commercially available
limescale remover, e.g. limescale re-
mover for coffee machines. Comply
with the instructions on the packaging
of the limescale remover. You can find
the next steps in the instructions of the li-
mescale remover. Rinse the kettle multi-
ple times after descaling, if necessary.
__339531_B8.book Seite 19 Freitag, 20. Dezember 2019 5:10 17