Silvercrest 336958 2001, Operating Instructions Manual

Page: 27 / 104

■ 24 │
GB
│
IE
SMK 1000 B2
Low liquid level control
The integrated low liquid level control prevents the
appliance from starting when there is no liquid in
the blender jug
5
.
Cleaning and Care
Ideally, you should clean the appliance immediate-
ly after use. Dried food residue is more difficult to
remove.
DANGER –
RISK OF ELECTRICAL SHOCK!
► Ensure that no moisture can get into/onto the
built-in plug
4
and the safety socket
2
on
the blender jug
5
!
► Ensure that no moisture can get into/onto
the contact plug
1
on the lid on the blender
jug
8
!
Never immerse the lid
8
in water or other
liquids! Otherwise there is a risk of an
electric shock.
WARNING! RISK OF INJURY!
► Take care when cleaning the lid
8
and the
attached blades
6
! The blades
6
are
extremely sharp!
1) Add a little warm water and a drop of washing
up liquid to the blender jug
5
.
2) Place the lid
8
on the blender jug
5
. Ensure
that the contact plug
1
in the lid
8
fits cor-
rectly in the safety socket
2
.
3) Insert the connector
3
into the built-in plug
4
on the appliance.
4) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
5) Press the MODE button
0
repeatedly until the
BLEND programme indicator
t
starts to
flash.
6) Press and hold the START/STOP button
u
and
allow the appliance to run for about 20 seconds.
7) Remove the power plug from the mains power
socket.
8) Remove any stubborn residue in the blender
jug
5
or the blades
6
using a washing up
brush or a washing up sponge.
9) Afterwards, empty the blender jug
5
and
rinse it out thoroughly with clear water.
10) Wipe the exterior surfaces of the blender jug
5
with a moist cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance.
11) Wipe the lid
8
, blades
6
and sensor
7
with
a damp cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance. Ensure that no moisture can get into
the contact plug
1
on the lid on the blender
jug
8
!
12) Wipe the mains cable with a damp cloth.
13) Dry all parts well before re-use.
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location.