10 GB/IE
The product is not a toy or a climbing appara-
tus! Ensure that persons, especially children, do
not pull themselves up on the product or lean
against it. The product may fall over.
Check the product for damage before each
use. Only use the product in good condition.
Do not use the product if damage is visible or
suspected.
Ensure that the product has been assembled
properly and in accordance with these instruc-
tions for use. Improper assembly can lead to in-
juries and impair the product’s safety and
functionality.
Only trained personnel may replace or repair
seat height adjustment components with en-
ergy accumulators.
The safety gas spring may only be replaced or
repaired by trained specialist personnel.
Do not stand on the product.
120 kg
Please note the maximum weight
capacity of 120 kg. Exceeding this
weight limit may result in injuries
and / or product damage.
Never sit on the backrest or armrests.
The chair is equipped with rollers for hard floors.
If the chair is used on soft floor coverings, e.g.
carpets, foam mats, rubber mat, the rollers
should be replaced for safety purposes, since
these floor require the use of different rollers.
RISK OF PROPERTY DAMAGE!
We are
not liable for accidents that occur as a result
of non-observance of the above safety notes
or through incorrect handling.
Installation
Insert the five castors
1
into designated holes
at the bottom of the base
2
(see Fig. A).
Pull the protective cap off the safety gas spring
3
. Insert the safety gas spring
3
into the
center of the base
2
(see Fig. A).
Put the safety gas spring cover
4
on the
safety gas spring
3
(see Fig. A).
Connect the seat plate
5
to the seat
7
. Use
the provided four screws
9
and tighten them
with the hexagonal key
11
(see Fig. B).
Attach the backrest
6
and armrests
8
to the
seat
7
. Use the provided eight screws
10
and
tighten them with the hexagonal key
11
(see
Fig. C).
Insert the eight caps
12
into the holes on the
armrests
8
(see Fig. D).
Put the assembled seat on the safety gas spring
cover
4
(see Fig. E).
Seat settings
Raising the seat height
Stand next to the product and pull the handle
on the seat plate
5
up with one hand without
straining the seat
7
(see Fig. H).
Lowering the seat height
Sit on the product and pull the handle on the seat
plate
5
with one hand upwards (see Fig. H).
Variable seating position
Sit on the product and bring it to the desired
position by shifting your weight.
Adjustment of tilt tension
Turn the knob of seat mechanism to adjust the
tilt tension (see Fig. F).
Chair tilt lock / unlock
Push in the handle of seat mechanism to lock
the chair tilt. Pull out the handle to unlock (see
Fig. G).
