Silvercrest 315311, Operating Instructions Manual

Page: 12 / 40

SDBS 2800 A1
GB
│
IE
│
NI
│
CY
│ 9 ■
Automatic switch-off
This steam iron is fitted with an automatic switch-off
system . This stops the iron from heating up .
If the iron is resting on its sole
q
and is not moved
for about 30 seconds, there will be a warning
beep and the AUTO OFF control lamp
0
flashes .
The iron will stop heating up . To deactivate the
automatic switch-off, lift up the iron and move it
gently from side to side . The AUTO OFF control
lamp
0
goes out and the iron will heat up again .
If the iron is on its base
9
and is not moved for
about 1 minute, there will be a warning beep and
the AUTO OFF control lamp
0
flashes . The iron
will stop heating up . To deactivate the automatic
switch-off, lift up the iron and move it gently from
side to side . The AUTO OFF control lamp
0
goes
out and the iron will heat up again .
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power! This is merely intended to reduce the fire
hazard if you forget to switch off the iron!
Cleaning
Self-cleaning function
■ Fill the water tank to the "MAX" marking .
■ Insert the plug into the mains power socket .
■ Move the temperature control
6
to the "MAX"
position .
■ Use the steam quantity button
5
to select steam
level 3 .
■ Allow the steam iron to heat up until the control
lamp "LINEN"
0
lights up permanently .
■ Hold the steam iron horizontally over a suitable
container .
NOTE
If your hands are sensitive to heat, wear oven
gloves . Hot steam escapes during cleaning .
■ Press the self-clean button
w
and keep it
pressed . Move the steam iron back and forth a
little .
Steam and boiling water will flow from the
steam exit holes in the sole of the iron
q
. Any
impurities and limescale that may be present are
flushed out .
■ Release the self-clean button
w
as soon as all
of the water in the water tank is used up .
■ Dry the sole of the iron
q
thoroughly . To do
this, move the sole of the iron
q
back and forth
several times over a towel or an old piece of
material .
■ Allow the steam iron to cool down before putting
it away .
Housing and sole of the iron
MORTAL DANGER!
► Always remove the plug before cleaning the
appliance . There is a risk of electric shock!
RISK OF INJURY!
► Allow the appliance to cool down before
cleaning it . Otherwise, there is a risk of burns!
CAUTION! PROPERTY DAMAGE!
► Do not use aggressive, abrasive or chemi-
cal cleaning agents . They can damage the
surface and also lead to irreparable damage
to the appliance .
■ Clean the housing with a soft, dry cloth only .
■ Clean the sole of the iron
q
using a damp cloth
and a mild, non-scouring detergent .
■ Dry the appliance well before using it again .
Storage
Store the cooled-down appliance in a clean, dust-
free and dry location .