■
40
│
GB│MT
SVM 3.7 A1
Use
WARNING! RISK OF INJURY!
To avoid bruises:
►
Before switching on, make sure that appliance is set to the lowest intensity
(dial
1
to "L" = LOW, low suction) . Always start with the lowest intensity
and increase this gradually if required (dial
1
direction "H" = HIGH,
strong suction) .
►
Be especially careful when treating sensitive and non-firm regions of the
body, such as the face!
►
Do not treat the same region of the body for too long or with too much
force . Do not treat the same area several times in succession .
►
Every body reacts differently . If you find an application unpleasant, reduce
the intensity, try another region of body or stop the treatment completely .
NOTE
►
Use the appliance every two days until you are satisfied with the result .
►
Use the appliance only on regions of the body with sufficient fat tissue .
Application on fat-free regions does not achieve any effect and will usually
be experienced as unpleasant .
►
Rub the areas to be treated with a small amount of a cosmetic product
containing oil (e .g . body oil) so that the appliance slides over the skin more
smoothly .
►
You can stop the vacuum at any time by turning the dial
1
.
♦
Fit the appropriate attachment
8 9
. See the
Attachments
section .
♦
Use the programme switch
3
to select the appropriate programme .
See the
Programmes
section .
♦
Make sure the dial
1
is set to "L" (= LOW, low suction) .
♦
Hold the opening of the attachment
8 9
on the area to be treated and
move the On/off switch
2
to "ON" . The control lamp
4
lights up green in
battery mode, or orange if the appliance is charging at the same time .
The appliance immediately starts to suck in air and a vacuum is formed in the
attachment
8 9
.
♦
Move the appliance over your skin following the movements described in the
Typical applications
section .
♦
Change to an adjacent area
in the suction pause . Make sure the areas do
not
overlap . You should not treat the same area several times in succession!
Summary of Contents for 313165
Page 3: ......
