Silvercrest 295773, Operating Instructions Manual

Page: 26 / 102

SDB 2400 F4
GB
│
IE
│ 23 ■
Pausing operation of the steam iron
WARnInG – RISK oF FIRE!
► Never leave a hot steam iron unattended if it is switched on or connected
to the mains power supply .
1) Move the temperature control
8
to the "MIN" position .
2) Stand the steam iron only on the base
0
.
After use
■ Remove the plug from the mains power socket .
■ Empty the water tank and clean the sole of the iron
q
.
■ Place the cooled-down steam iron on the base
0
.
Drip-stop function
With conventional steam irons, water can drip from the sole of the iron
q
at
low temperatures . This iron however, possesses a new feature, the DRIP-STOP
function . At low temperatures, the iron automatically switches off the steam-
blast function . When this happens, you will hear a "CLICK" . Then set a suitable
temperature with the temperature control
8
. As soon as this is reached, steam
production is resumed .
Automatic switch-off
This steam iron is fitted with an automatic switch-off system . This stops the iron
from heating up .
If the iron is resting on the sole of the iron
q
and is not moved for about 30
seconds, you will hear a warning beep and the control lamp for the automatic
switch-off
6
will flash . The iron will stop heating up . To deactivate the automatic
switch-off, lift up the iron and move it gently from side to side . The control lamp
for the automatic switch-off
6
goes out and the iron will heat up again .
If the iron is on its base
0
and is not moved for about 8 seconds, there will be a
warning beep and the control lamp for the automatic switch-off
6
flashes . The iron
will stop heating up . To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side . The control lamp for the automatic switch-off
6
goes out and the iron will heat up again .
IB_295773_SDB2400F4_LB8.indb 23 17.10.17 16:48