Silvercrest 280641, Operating Instructions Manual

Page: 13 / 94

■ 10
│
GB│CY SDM 1500 C2
2) If not already done: Completely unwind the power cable from the cable
hooks
z
/
i
. To facilitate the unwinding of the cable, you can fl ip down the
upper cable hook
z
by pulling it out a little and turning it at the same time.
3) Run the cable through the notch
t
on the rear of the handle so that the
cable does not hang down into the working area.
4) Insert the plug into the mains power socket.
5) Set the on/off switch
u
to “I”. The on/off switch
u
lights up, the red
POWER control lamp
0
fl ashes.
6) Use the MODE button
e
to select the desired level of steam generation:
–
Press 1 x: low steam level, green control lamp
w
lights up.
–
Press 2 x: high steam level, red control lamp
q
lights up.
–
Press 3 x: no steam, standby, POWER control lamp
0
lights up.
NOTE
► We recommend the high steam level especially for moisture- and heat-
resistant fl oor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and heat-
sensitive fl oor coverings, such as parquet fl ooring.
7) Wait around 30 seconds while the appliance heats up.
8) Press the “Steam” button
r
. The appliance starts generating steam and,
after a short time, steam is emitted through the pad
6
.
9) Wipe over the desired area.
If the water tank
8
becomes empty during use:
NOTE
► Once the water tank
8
has been pumped empty, the pump will continue
running a little while until the empty water tank
8
is indicated by the simul-
taneous fl ashing of the red control lamp “high steam level”
q
, the green
control lamp “low steam level”
w
and POWER control lamp
0
.
–
Press the “Steam” button
r
again to stop steam production.
–
Set the on/off switch
u
to “O”.
–
Remove the water tank
8
, fi ll it and replace the water tank
8
as
described in the section “Filling with water”.
–
Set the on/off switch
u
to “I”.
–
Select the desired steam level as described above and press the
“Steam” button
r
.