Silvercrest 279508, Operating Instructions Manual

Page: 13 / 185

■ 10 │
GB
SMK 1000 A1
Low liquid level control
The integrated low liquid level control prevents the
appliance from starting when there is no liquid in
the blender jug
.
Cleaning and Care
Ideally, you should clean the appliance immediate-
ly after use. Dried food residue is more difficult to
remove.
DANGER –
RISK OF ELECTRICAL SHOCK!
► Ensure that no moisture can get into/onto the
built-in plug
and the safety socket on
the blender jug !
► Ensure that no moisture can get into/onto
the contact plug
on the lid on the blender
jug !
Never immerse the lid in water or other
liquids! Otherwise there is a risk of an
electric shock.
WARNING! RISK OF INJURY!
► Take care when cleaning the lid and the
attached blades ! The blades are
extremely sharp!
1) Add a little warm water and a drop of washing
up liquid to the blender jug .
2) Place the lid on the blender jug . Ensure
that the contact plug in the lid fits cor-
rectly in the safety socket .
3) Insert the connector into the built-in plug
on the appliance.
4) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
5) Press the MODE button repeatedly until the
BLEND programme indicator
0
starts to
flash.
6) Press and hold the START/STOP button
6
and
allow the appliance to run for about 20 seconds.
7) Remove the power plug from the mains power
socket.
8) Remove any stubborn residue in the blender
jug or the blades using a washing up
brush or a washing up sponge.
9) Afterwards, empty the blender jug and
rinse it out thoroughly with clear water.
10) Wipe the exterior surfaces of the blender jug
with a moist cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance.
11) Wipe the lid , blades and sensor with
a damp cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water to
ensure that no detergent remains on the appli-
ance. Ensure that no moisture can get into the
contact plug on the lid on the blender jug
!
12) Wipe the mains cable with a damp cloth.
13) Dry all parts well before re-use.
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location.