Silvercrest 273340, Operating Instructions Manual

Page: 17 / 60

SOR 2600 C1
■ 14 │
GB
│
IE
Assembly
Use the fold-out page of these instructions to assist
you with assembly.
1) Remove the oil radiator and all components from
the box and remove all packaging materials.
2) Place the oil radiator, with the base uppermost,
on a soft surface, for example a carpet.
3) Place a mounting bracket under the heater
element so that the threaded parts project
upwards.
4) Lay a roller rail over it, such that the screw
threads protrude through the holes. Check to
ensure that the recesses on the roller rails
are facing outwards. The screw ends project-
ing from the appliance must reach into the
recesses.
5) Screw one wing nut hand tight onto each of
the threaded ends of the mounting bracket .
6) Proceed in the same manner with the other side.
7) Turn the appliance over and place it on the rollers.
Initial operation
1) Unwind all of the power cable from the power
cable retainer .
NOTE
► Ensure that the thermostat and the heat
level switch are standing at MIN resp. 0.
2) Insert the plug into a mains power socket.
3) Set the heat level switch
to “3” and the
thermostat to MAX. The “Power” control
lamp illuminates.
NOTE
► You can use the heat level switch to regu-
late how quickly the appliance warms up.
If you wish to heat it up particularly quickly,
select heat level "3", if a slow warming up is
preferred, select heat level "1".
Using the thermostat
you can set it to the
desired temperature.
4) When the desired room temperature has been
reached, slowly turn the thermostat back
down until a quiet “click” is heard and the
“Power” control lamp
goes out. The current
room temperature will now be retained. The
“Power” control lamp
will light up occasion-
ally then switch back off after a short while.
This merely means that the programmed room
temperature has fallen below this level for a
short period and the appliance has warmed
itself back up.
NOTE
► If you want to heat a room up particularly
quickly, you can also activate the heating fan
switch
. When the fan heater is switched
ON, the heating fan control lamp illumi-
nates and hot air is blown through the hot air
outlet
into the room.
5) If you wish to switch the appliance off, first set the
heating fan switch to OFF so that the heating
fan control lamp goes out. Next, turn the
heat level switch to to “0” and then the
thermostat to MIN.
6) Remove the plug from the mains power socket.