11
GB/IE
If the above instructions are not complied
with, the batteries may discharge them-
selves beyond their end voltage. There is
then a danger of leaking. If the batteries
have leaked inside your device, you should
remove them immediately in order to pre-
vent damage to the device!
Avoid contact with the skin, eyes and
mucous membranes. Any parts of the body
coming into contact with battery acid
should be rinsed off with copious amounts
of water and / or a doctor contacted if
necessary!
Preparing the product for use
Remove the insulation strip from the battery compartment
4
.
Replacing the batteries (Fig. B)
Open the battery compartment
4
on the back of the scale.
Remove the used batteries, if present.
Insert 2 x 1.5 V AAA batteries into the battery compart-
ment
4
.
Note:
Make sure you fit the batteries the right way round
(polarity). The correct polarity is shown inside the battery
compartment
4
.
Close the battery compartment
4
.
Setting the time (Fig. A)
After you have inserted the batteries, the scale switches auto-
matically into the time mode
5
. As soon as the scale has
switched into the time mode
5
, the hour value flashes in the
LC display
1
. In this event, skip the next two steps.
If the scale is in the weighing mode, press and keep pressed
the MODE button
3
for approx. 2 seconds to switch into
the time mode
5
.
Press and keep pressed the TARE button
2
for approx.
3 seconds to set the time.
Press the MODE button
3
to set the desired hour value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting. Then the
minute value flashes.
Press the MODE button
3
to set the desired minute value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting.
Note:
If you do not press another button within 60 seconds,
the set value stops to flash and the time is set.
Operation
Weighing (Fig. A)
If the scale is in the time mode
5
, press the MODE button
3
once to switch into the weighing mode.
Note:
Shortly before the scale switches into the weighing
mode, the scale shows “HELO” in the display for 1–2 sec-
onds.
1. Place the kitchen scale on a solid, flat surface.
100926_silv_Digitale Kuechenwaage_Content_IE_FI_SE_DK_BE.indd 11
03.06.14 12:07
