Attention:
Turn power switch to off
(
when carrying out any of the
above operations!
"O")
Change the needle regularly, especially
if it is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle.
The flat side of the shaft should be
towards the back.
B. Insert the needle as far up as it will go.
Needles must be in perfect condition.
Problems can occur with:
- Bent needles
- Blunt needles
- Damaged points
A
B
REPLACING THE NEEDLE
CHANGING THE PRESSER FOOT
b
d
c
f
e
a
e
1
2
3
4
b
a
g
(1)
Raise the presser foot bar (a). Attach the
presser foot holder (b) as illustrated.
(2)
Lower the presser foot holder (b) until
the cut-out (c) is directly above the pin (d).
Raise the lever (e).
Lower the presser foot holder (b) and the
presser foot (f) will engage automatically.
(3)
Raise the presser foot.
Raise the lever (e) and the foot will
disengages.
(4)
Attach the seam guide (g) in the slot as
illustrated. Adjust according to need for
hems, pleats, etc.
Attention:
Turn power switch to off
("O") when carrying out any of the
above operations!
Attaching the presser foot holder
Attaching the presser foot
Removing the presser foot
Attaching the seam guide
9
