PACKING LIST
Nemo 210 SD:
Boat Hull with Roll-up Slat Floorboards, Oars, Foot Pump, Pressure Gauge, Docking Rope, Grab Safety
Handles, 3 Screw 1 Drain Valve, Repair Kit, Carry Bag and Boat cover.
Nemo 230 SD & Nemo 250 SD:
Boat Hull with Roll-up Slat Floorboards, Oars, Foot Pump, Pressure Gauge, Wooden Seat, Docking
Rope, Grab Safety Handles, 3 Screw 1 Drain Valve, Repair Kit, Carry Bag, Bench Seat and
Boat cover.
INSTALLATION TIPS
Tip 1: Although the boat is designed to be assembled by one person, an additional person can make it
substantially easier.
Tip 2: Make sure to press down and turn the pop-up spring valve 90 degrees before inflating. (The default
setting is for deflation.)
Tip 3: If using an electric pump, after tube inflation, use a foot pump to add a little more air to ensure
correct pressure.
Tip 4: In case the valve is loose, screw it tight with the black plastic wrench included in the accessories.
Tip 5: In case you find difficulty when installing the bench seat, put your knees on one of the inflated
tubes to add pressure to the bench handle.
HOW TO SET UP THE BOAT?
STEP ONE: UNFOLD THE HULL
Clear a flat area (make sure it is clean and free of sharp objects). Remove the hull from box and take off
the plastic bag. NEMO SD series is the easiest tender to set-up; it has slat floorboards ready to
assemble, so just unroll the hull and lay it out flat, then inflate. You will finish by installing the oars on the
tubes.
1. Take off the top of the valve. (The valve
by default is at deflation position)
2. Press down the spring switch and turn it clockwise by
90 degrees. Make sure the switch is popped up.
Note: To deflate, press the inner button at the center and
turn counterclockwise 90 degrees.
1
2.2
UP
DOWN
(A) INFLATE
(B) DEFLATE
2.1
PRESS AND TURN 90
5
Summary of Contents for Nemo 210 SD
Page 74: ......
