fitting the Support Leg (
see illustrations
14 - 16)
• Once the safety seat has been fastened onto the vehicle seat using the Isofix system and
its correct installation has been checked (see
green
line on the outer side of both of the
connector release devices).
• Remove the two stoppers from the front part of the base (
fig. 14
).
• Simultaneously press the two pivot pins on the upper tubes of the support leg.
• Insert both of them into the front slots making sure they go in simultaneously to stop them
from blocking (
fig. 15
). When they click they are fastened correctly.
• Pull the
red
release catch outwards with one hand, while, with the other hand, press the
telescopic support of the leg against the floor of the vehicle. Release this part and check
that the leg is not in-between two locking positions (
fig. 16
).
• If the leg is in-between two positions, pull the
red
release catch outwards again and
lengthen or shorten the leg to the upper or lower locking position to obtain the maximum
support possible.
removing the Explorerfix seat with Support Leg (
see illustrations
17 - 18)
• Pull the
red
release catch outwards with one hand, while the other hand folds up the
telescopic support (
fig. 17
).
• Simultaneously press the two buttons on the upper part of the base and at the same time
pull the upper tubes of the support leg (
fig. 18
).
• Next, loosen the Explorerfix seat by pulling the front knob outwards and turning it to the
right to create a space between the seat and the backrest of the vehicle.
• Disconnect the Isofix system by pulling the buttons on both sides of the connector release
devices. A
red
line will appear on them if it is correct.
• Remove the seat from the vehicle seat.
Important WarnInG:
*DO NOT USE ON PASSENGER SEATS FITTED WITH A
FRONT AIRBAG UNLESS YOUR VEHICLE MANUFACTURER CONFIRMS IT IS SAFE
Group 1 (9 - 18 KG.)
Installation of the Explorerfix seat facing forwards with three-point
seat belt (car seat belt) (
see illustrations
19 - 22)
• Place the seat on the front
*
or rear seat of the car.
• Pass the lap section of the seat belt through the guides on both sides (
fig. 19
), fasten
the buckle and tighten the belt.
• Next, pull the chest part of the seat belt passing it through the clip (fig.
20 - 21
).
• Fasten the safety catch (
fig. 22
).
adjusting the crotch strap (
see illustration
23)
• Press the adjuster and at the same time place it in the desired position (
fig. 23
),
making sure that the lap section of the harness is positioned as low as possible so the
pelvis is firmly secured.
