Siliken se2.8i, User Manual

Page: 38 / 82

Operation
37
user’s manual inverter SE2.8i - SE3.8i - SE4i - SE5i
During the System Check, if the DC input voltage is not reaching the point of the PV start voltage setting, , then the following message will
be shown on the LCD and the system will stay at this step.
During the System Check, if the grid is not connected to the inverter, then the inverter enters to Fault mode and following message will be
shown on the LCD.
Monitoring Mode :
Once the System Check is done, the inverter goes into the Monitoring mode. If all data needed for grid feeding is in the acceptable range,
the system will keep monitoring those data for a period of time. The following information tells users that the system will go into the Grid/MPP
mode in XXX seconds late and then show the measured data of the DC input voltages and the existing voltage and frequency on the grid side.
L o w I n s o l a t i o n
M o d F a e u l t
G r i d N A
M o d o r e i n g
N e x t C o
t i n o M
n n e c t X X X s