Silicon Laboratories UDP C8051F370, User Manual

Page: 2 / 38

C 8 0 5 1 F 3 9 x / F 3 7 x
2 Rev. 0.2
3. Hardware Setup
3.1. Using the MCU Card Alone
Refer to Figure 2 for a diagram of the hardware configuration when using the MCU card without a UDP
motherboard.
1. Connect the USB Debug Adapter to the 2x5 debug connector on the MCU card with the 10-pin ribbon
cable.
2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter.
3. Connect the other end of the USB cable to a USB Port on the PC.
4. Move the SW1 switch to the VREG position.
5. Connect the 9 V DC adapter to P1.
Notes:
 Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
 Remove power from the MCU card and the USB Debug Adapter before connecting or disconnecting the
ribbon cable from the MCU card. Connecting or disconnecting the cable when the devices have power can
damage the device and/or the USB Debug Adapter.
Figure 2. Hardware Setup Using the MCU Card Alone
USB Debug Adapter
USB
Connectivity
Power
Adapter (P1)
VDD
Selection
Switch