To o l St i c k - C a p To u c h S e n s e D C
6
Rev. 0.3
6. ToolStick CapTouchSense Daughter Card Memory Game Demo
The ToolStick CapTouchSense Daughter Card is pre-loaded with a memory game firmware that can be played
without connecting to the ToolStick Base Adapter. When disconnected from the ToolStick Base Adapter, the
daughter card may be powered from the included A76 alkaline battery. When connected to a ToolStick Base
Adapter, the daughter card can be powered from the USB port.
6.1. Hardware Setup
To use the CapTouchSense Daughter Card in standalone mode (battery powered) perform the following steps:
1. Insert the A76 alkaline “button cell” battery into the battery holder (BAT1) ensuring that the “+” terminal is on the
top side as marked on the battery holder.
2. Set the Power Select Switch (S1) to select Battery Power (BAT PWR). The yellow power source indicator LED
should be OFF.
To use the CapTouchSense Daughter Card with a ToolStick Base Adapter (USB powered) perform the following
steps:
1. Connect the ToolStick Base Adapter to the ToolStick CapTouchSense Daughter Card taking note of the
recommendations in Section 1.
2. If available, connect the USB extension cable to the ToolStick Base Adapter.
3. Set the Power Select Switch (S1) to select ToolStick Power (TS PWR). The yellow power source indicator LED
should be ON.
4. Connect the ToolStick to a USB port on a PC.
See Figure 5 for an example hardware setup using the C8051F330 ToolStick Daughter Card.
Figure 5. Hardware Setup Example
