2. Quick Start and Jumper Defaults
1. Install ClockBuilder Pro desktop software from EVB support web page given in Section 1.
2. Connect the USB cable from Si5383-EVB to PC with ClockBuilder Pro software installed.
3. Connect the SIOCXO1-EB to the reference input using the included SMA cable.
4. Leave the jumpers as installed from the factory, and launch the ClockBuilder Pro software.
5. You can use ClockBuilder Pro to create, download, and run a frequency plan on the Si5383-EVB.
6. For the Si5383 data sheet, go to
http://www.silabs.com/timing
Table 2.1. Si5383 EVB Jumper Defaults
1
Location
Type
I = Installed O =
Open
Location
Type
I = Installed O =
Open
JP2
2 pin
I
JP21
3 pin
O
JP3
2 pin
I
JP22
2 pin
O
JP4
2 pin
I
JP23
2 pin
O
JP5
3 pin
I
JP24
3 pin
O
JP13
2 pin
O (Jumper sup-
plied)
JP25
2 pin
O
JP14
2 pin
O
JP26
3 pin
O
JP15
2 pin
O
JP27
2 pin
O
JP16
3 pin
O
JP28
3 pin
O
JP17
3 pin
O
JP29
2 pin
O
JP18
2 pin
O
JP31-J34
2 pin
Probe Points
JP19
2 pin
O
J48
3x2 Hdr
3 installed
JP20
3 pin
O
J22
5x2 Hdr
O
Note:
1. Refer to the Si5383 EVB schematics for the functionality associated with each jumper.
2. J31-J34 are intended to be probe points and jumpers should not be installed.
UG256: Si5383 Evaluation Board User's Guide
Quick Start and Jumper Defaults
silabs.com
| Building a more connected world.
Rev. 1.2 | 3
