Silicon Graphics 1200, User Manual

Page: 52 / 62

38 007-4075-001
A: Regulatory Specifications
Manufacturer’s Declaration of Conformity
A “Manufacturer’s Declaration of Conformity” is available on the World Wide Web.
Look on your system (regulatory) label on the system to determine your CMN (model)
number, and on the serial number label to determine your series number. You need both
to identify your Declaration of Conformity. To locate the information on the World Wide
Web, enter the following in your Web browser location window:
http://www.sgi.com/compliance
Upgrade Regulatory Label
If you received a regulatory label with an upgrade, place it on the system near the
Manufacturer’s Declaration of Conformity label.
Class A Compliance
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.