6
Operating Instructions
Setting the
Temperature
The temperature range can
be set as low as 39
°
F (4
°
C)
or as high as 64
°
F (18
°
C) to
suit your specific storage
requirements. Each depres-
sion of the or but-
ton will allow you adjust the
temperature in 1
°
degree
increments within the afore-
The Controls of your
Wine Cooler
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. ‘ ’ Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. ‘ ’ Button
To control the inner light turn ON/OFF.
(If you press this button, the inner
light is not controlled by the reed
swith, and keep lighting.)
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
5. ‘
’
Button
Used to raise (warmer) the temperature
in 1° degree increments.
‘
’
Button
Used to decrease (cooler) the
temperature in 1° degree decrements.
mentioned range.
°
°
To switch the display
between the Fahrenheit (
°
F)
and Celsius (
°
C) scale,
depress the and
control buttons simultaneo-
usly for approximately
five(5) seconds.
NOTE
When you plug in your
wine cooler for the first
time, the temperatures
will automatically be set
to 54°F (12°C) and will be
displayed in the
Fahrenheit scale (°F).
Function
instruction
Temperature Memory Function
Door Ajar Alarm Function
T
emperature Alarm Function
NOTE
In the event of a power interruption the Wine Cooler can remember the
previous temperature settings, and when the power is restored the
cabinet temperature will go back to the same setting temperature as
before.
If the door is not closed completely the alarm will sound after 5 minutes.
Please close the door completely to avoid the loss of cold energy.
once or the door has not been
closed tightly, the unit will display the
after you close the door and
“HI” will disappear.
It is normal that the cabinet
shows “HI” or “LO” from time to time,
If it occurs frequently or lasts for a
long time, you can restart the unit by
unplugging it. If the problem
occurs once again after restart,
If too many bottles are put in at
"HI" signal in the display panel. This
is normal. Please wait 5 minutes
please contact customer service.
If inner temperature is higher than 73°F(23°C), “HI” is shown
in the display panel, and the alarm will sound after one hour.
If inner temperature is lower than 32°F(0°C), “LO” is shown in the
display panel and the alarm will
sound
.
Refer to the trouble shooting
guide on page 11 for more information.
