2
INSTALLATION INSTRUCTIONS
BEFOR USING YOUR
ALL REFRIGERATOR
INSTALLATION OF YOUR
ALL REFRIGERATOR
• Remove the exterior and interior packing.
• Before connecting the refrigerator to the power source,
let it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a
soft cloth.
• When replacing the illuminating light, please select the
light which comply with the rated power input according
to the rating label. Shut off the power supply before
replacing the light.
• When disposing your appliance, please choose an
authorized disposal site.
• Place your refrigerator on a floor that is strong enough
to support it when it is fully loaded. To level your
refrigerator, adjust the front leveling leg at the bottomof
the refrigerator.
• Locate the refrigerator away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to
perform properly.
• Avoid locating the unit in moist areas.
• Plug the refrigerator into an exclusive, properly
installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong
from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified
electrician or an authorized Products service center.
ATTENTION
• Store beverage in sealed bottles;
• Do not overload the cabinet;
• Do not open the door unless necessary;
• Do not cover shelves with aluminum foil or any other
shelf material which may prevent air circulation;
• Should the refrigerator be stored without use for long
periods it is suggested, after a careful cleaning, to leave
the door ajar to allow air to circulate inside the cabinet in
order to avoid possible formations of condensation,
mold or odors.
