Operating manual - English
TARGA 2000
18
Copyright Silca 1999
Fig. 16
6.5
Cutting female bit and double bit keys
1) Align the mobile clamp (cutting tool side) by means of the carriage locking knob (fig. 18).
2) Fit the special centring devices (G1) into their seat, pushing all the way in.
3) Loosen knob (E1).
4) Place the original key into the jaws, pushing up against the centring device (G1).
5) Push the key into the centring device so that the bit butts against the stop (fig. 18).
6) Secure the key in this position by tightening the knob (E1).
7) Place the key to be cut in position and repeat steps 3, 4, 5, 6, in that order.
8) Take the head stop (H) up against the key to be cut and lock the knob (H1).
9) Lock the centring device knobs (G2) to avoid vibrations.
10) Release the carriage by means of the knob (D2).
11) Turn on the key-cutting machine by means of the motor ON switch (N).
12) Take the carriage up to the tracer point and cutting tool by raising the carriage lever (A).
13) Grip the lever (B), turn upwards to avoid the cutting tool coming into violent contact with the bit
and cut the tooth.
14) Rest the tracer point properly on the bottom of the cut and round it off by moving the carriage
up and down.
15) Repeat this operation for all the cuts on the bit.
16) It is advisable to rectify the side of the key opposite the stop (fig. 17)
17) For double bit keys, use the same procedure to cut the second side.
Fig. 17
E1
B
E1
G2
H1
G2
D2
H
side to
stop
rectify
