Operating Manual
Matrix
Copyright Silca 2012
15
Matrix EVO version
Tracer point
Fitting:
-
insert the tracer point all the way into the spindle with the numbered ring
towards the clamp.
-
hold the tool in this position and tighten the grub screw (G3) with the hex
wrench provided.
Removing:
-
loosen the grub screw (G3) with the hex wrench and remove the tool.
Fig. 18
Cutter
Fitting:
-
insert the cutter into the spindle with the numbered ring towards the clamp.
-
hold the tool in this position and tighten the grub screw (G4) with the hex wrench.
Removing:
-
loosen the grub screw (G4) with the hex wrench and remove the tool.
8.2 MICROMETER GAUGE
The micrometer gauge is used for tool alignment and also for adjusting small
variations in depths often necessary on worn keys.
After tool alignment (green bar) the depth of cuts can be reduced or increased
by turning the micrometer gauge (V) to the left or right.
Each line on the gauge corresponds to an increase of 0.02 mm.
Fig. 19
•
Turn the gauge clockwise to make cuts less
deep.
•
Turn the gauge anti-clockwise to make cuts
deeper.
