Silca DUO BRAZIL, Operating Manual

Page: 37 / 47

Operating manual - English DUO
Copyright Silca 2 010 35
9.3 Replacing the brush
When the brush no longer cleans off the burrs it must be replaced as follows.
ATTENTION: remove the mains plug.
1) Place the locking rod (provided) in position on the motor shaft.
2) Use the Allen wrench (provided) to loosen the screw holding the brush in place (fig. 48).
3) Replace the brush and tighten the screw with the Allen wrench.
4) Remove the locking rod from the motor shaft.
Fig. 48
9.4 Replacing and/or tightening the belt
Worn or loose belts must be replaced or adjusted so as to ensure safe and proper operation of the cut-
ting tool/ brush.
Tension:
ATTENTION: remove the mains plug.
1) Loosen the 4 screws (Q1) and remove the top cover (Q) (fig. 49).
2) Access the bottom part (chap.9.2, page 34) and loosen the 4 nuts (S1) of the plate motor (fig. 50).
3) Push the motor back until the belt is properly tightened.
4) Tighten the four nuts (S1).
5) Place the machine in position on the work bench.
Fig. 49
locking rod
brush holding
screw
tighten
loosen
T
T
Q1
Q1