Silca DUO BRAZIL, Operating Manual

Page: 19 / 47

Operating manual - English DUO
Copyright Silca 2 010 17
7.3
Calibration - RIGHT-HAND CARRIAGE
Axis calibration
Axial gauging is regulation of the spaces for the cuts on the key (fig. 18).
Fig. 18
Axis gauging control
1) Turn off the machine and unplug the power lead.
2) Make sure the tracer point and cutter are of the same thickness.
3) Lock the tilting movement of the clamps by inserting the pin (L) into its seat.
4) Close the 2 clamps with their knobs (K).
5) Release the carriage by turning the pin (B1) (not available on Duo Brazil version).
6) Use the lever (H) to raise the carriage and take the right-hand side of the clamp up against the left-
hand side of the tracer point and cutter (fig. 19).
7) The ideal condition is for both tools (tracer point and cutter) to be in contact with the relative side of
the clamp. If this is not so, loosen the 2 tracer point holder screws (N2) (fig. 19) and move the tracer
point holder manually (right or left) until the ideal condition is found.
8) Tighten the 2 screws (N2).
Fig. 19
cutting space
cutting
depth
L H
K
K
N3
B1
N2