Siko MSK400/1, Original Installation Instructions

Page: 23 / 28

MSK400/1
Commissioning English
MSK400/1 · Date 07.02.2018 · Art. No. 81145 · Mod. status 44/18
23
5 Commissioning
Following correct mounting and wiring you can put the measuring system
into operation by switching on operating voltage.
6 Trouble shooting
Below are some typical errors which may occur during installation and
operation:
• Magnetic tape wrongly mounted, active side below (see chapter
4.2
).
• The masking tape provided was not used for protecting the magnetic
tape. The masking tape must not be magnetizable.
• Magnetic sensor not or incorrectly connected (pin assignment see
chapter 4.4 ).
• The distance tolerances were not observed over the whole measuring
length (see Fig. 6 ).
• Cable squeezed / interrupted / cut by sharp edges.
• The magnetic sensor has been mounted with the active side turned
away from the band (see
Fig. 6
).
• Magnetic sensor has not been aligned according to
Fig. 6
.
7 Transport, Storage, Maintenance and Disposal
Transport and storage
Handle, transport and store the magnetic sensor with care. Pay attention
to the following points:
• Transport and / or store the magnetic sensor in the unopened origi-
nal packaging.
• Protect the magnetic sensor from harmful physical influences includ-
ing dust, heat and humidity.
• Do not damage connections through mechanical or thermal impact.
• Prior to installation inspect the magnetic sensor for transport dam-
ages. Do not install damaged magnetic sensors.
Maintenance
With correct installation according to chapter
4
the magnetic sensor
requires no maintenance. Clean the surface of the magnetic tape with soft
cloth from time to time if it is very dirty.