6
If you stopped config utility by
Exit
function, you will not
be able to maintain the wireless link to the access point you
wish to use. In this case, you can start config utility again
by clicking
Start, All Programs, Ralink Wireless
,
Ralink
Wirelss Utility
.
Connecting to Wireless Access Point
After the driver is correctly installed, it will try to connect
to any unencrypted wireless access point automatically. If
you want to connect to a specific wireless access point, or
the access point you wish to connect uses encryption, you
have to configure the wireless network card and input
required parameters, to get connected to the wireless
access point you wish to connect. There are two ways you
can configure your wireless network card to connect to
wireless access point: using the Ralink configuration utility
which comes with wireless card driver, and using built-in
windows zero configuration utility.
Using Ralink Utility
Please follow the following instructions to use Ralink
configuration utility to connect to wireless access point.
1.
Right-click the Ralink configuration utility icon
located at lower-right corner of computer desktop,
then click
Launch Config Utilities
, shown in
Figure
3
in the next page.
Summary of Contents for Wireless-N CardBus Adapter
Page 25: ...25 Blank Page ...
Page 26: ...26 Blank Page ...
