SIIG ID-SB0111-S1, User Reference Manual

Page: 17 / 24

17
NAME=
Used to specify a name for the adapter.
You can specify a friendly name using 0 to 9, A to Z, a to z,
space and -, which are all valid characters. (Note: Using Space or
- as first or last space isn't permitted.) The default name is "Serial
Adapter".
(Default)
Serial
Adapter
Default device name
xx....xx "xx...xx" is a character string with the length from 2 to 30.
R Restore the default settings name="Serial Adapter".
? Inquire the name of the local adapter.
PARITY=
This command is used to specify parity bit setting of COM port.
The command will need 200 ms delay.
(Default) N None parity bit
O Odd parity
E Even parity
? Inquire the current setting.
PIN=
Used to designate a PIN. The default PIN is "1234". Paired
adapters should have the same PIN. This command is used to
designate a PIN. The default PIN is "1234" and the digits should
not be less than 4. Paired adapters should have the same PIN.
The PIN can be set up with combinations of numbers, English
characters or both.
(Default) 1234
xx....xx
"xx....xx" is a 4~16 digit string or English character (with capital
or lower case characters)
N Cancel authentication by PIN.
R Restore the default settings PIN="1234".
? Inquire the current PIN.
PROMPT=
Used to decide whether result messages are prompted when
Setup commands are executed. The result messages are:
OK/ERROR for command execution, or
CONNECT/DISCONNECT/Try Connect Device for connection
status.