25
11. FUNCTION SETTINGS
This printer can set various functions according to use conditions and intended use.
The setting contents are stored in the Memory Switch (hereinafter referred to as MS) in the FLASH
memory mounted in the printer, and it is possible to set MS by using the switches, software, or inputting
command.
This section describes the setting procedure by using the switches.
See "17 MS SETTINGS LIST" for the MS setting list.
HINT
•
The memory switch can also be set from software. Download software from the
download page listed on the rear cover.
The following software can be set.
･
For Windows:
"SII Printer Setting Utility" included in the printer driver
･
For iOS and Android: App "SII Printer Utility" provided by App Store or Google Play
■
Procedure for Setting Functions Using Switches
To set the functions using the switches, set the printer in the Setting Mode.
To enter the Setting Mode, follow the procedure below.
Load the thermal paper in the printer as instructed in "8. LOADING THERMAL PAPER".
Ensure that no error occurs, and then turn off the printer.
See "6. EACH PART OF PRINTER" for the error status.
Hold the FEED Switch down and press the POWER Switch, then release the POWER Switch.
Keep pressing the FEED Switch until the test print is completed.
A message of mode selection is printed as shown in Figure 11-1 when the test print has completed.
To enter the Setting Mode, press the FEED Switch.
Figure 11-1 Mode Selection Message
[Enter Setting Mode]
Enter Setting Mode: Feed SW
Exit: Power SW
