-5-
INSTALL
POSITION
DOOR ANGLE
ADJUST SCREW
4"
S
IG
H
T
L
IN
E
OPERATING
POSITION
TOP MOUNT
WALL MOUNT
INSTALL
POSITION
6 1/2"
SIG
HT
LIN
E
OPERATING
POSITION
DOOR ANGLE
ADJUST SCREW
SIG
HT
LIN
E
REV 03.11.1
Installation Instructions
Series CVRAC
LAMP & DOOR ASSEMBLY
1. Insert MR16 lamps. If required, to ease lamp insertion pull wires gently away from socket
to relieve spring tension on pin terminals.
2. Snap connector 1 from Door-Lamp assembly into lamp housing connector, place
Door-Lamp assembly in place using pins to locate in position, and tighten two #8-32
screws.
3. Rotate lamp brackets into desired lighting position for Wall or Ceiling installations.
4. Strip off plastic protector film on mirror doors before use.
5.
FOR CORRECT LIGHT DISTRIBUTION & DOOR OPERATION, SET DOOR
ANGLE BY ADJUSTING STOP SCREW USING 9 6/4" ALLEN KEY SUPPLIED,
ROTATE COUNTER CLOCKWISE AS FOLLOWS:
DIMENSION BETWEEN DOOR EDGES WHEN FULLY OPEN.
WALL MT
6 ½”
CEILING MT
3 7/8”
6.
To test fixture, turn off line power to fixture & switch to generator power.
