10
PNEUMATIC INFORMATION, Continued
AIR PRESSURE DROP
Confirm air pressure calibration by comparing it to a
master gauge placed in-line where the quick
disconnect fitting attaches to the tool.
Air pressure at the tool can then be monitored as
the tool cycles. Use the following information
shown on the chart below for comparing the various
minimum air pressures while the VT tool cycles.
If pressure readings fall below the minimums, inspect your air supply system as well as the tool
for worn and/or broken parts. Contact your Signode representative if you have any questions.
AIR LINE PRESSURE MINIMUMS FOR CYCLING TOOL
IN-LINE GAUGE READING PSI (BAR)
SUPPLY/STATIC
TAKE-UP
STALL
WELDING
90 (6.2)
61 (4.1)
80 (5.4)
75 (5.2)
PNEUMATIC CIRCUIT DIAGRAM
Summary of Contents for VT-16
Page 1: ...VT 16 19 TENSION WELD STRAPPING TOOL...
Page 5: ...5 MAJOR COMPONENTS...
Page 19: ...19 BLANK...
Page 25: ...25...
