12
04.20
Josef Kihlberg B560
7.7 REPLACE FEED SPRING OR PUSHER
1. Remove the stapling head as per (7.6).
2. Remove the tension pin (pos. 22, exploded draw-
ing on page 53) with a punch with size 4,9 mm.
3. Dismantle the o-ring (pos.26) holding the lockpin
(pos. 24) and remove the pin.
4. Remove the pusher (pos. 12), feed spring
(pos. 18) and rollers (pos. 25).
5. Replace defective parts.
6. Assemble in reverse order.
7. Assemble the stapling head to the machine.
8. Adjust the stapling head as described (7.5)
7.6 REPLACE STAPLING HEAD
1. Remove the remaining staples and place the
pusher in its forward position.
2. Disassemble the two hexscrews holding the links
to the stapling head. (Fig. 15/1)
3. Disassemble the two cylinder screws holding the
stapling head to its bearing. (Fig. 15/2)
4. Replace the stapling head and assemble in
reverse order.
5. Adjust the stapling head to the anvil as described
(7.5).
Fig. 15
7.8 REPLACE DRIVER BLADE / RETURN SPRINGS
1. Remove the stapling head as per chapter (7.6).
2. Dismantle the four screws (Fig. 16/1) and remove
the unit from the rail.
3. Dismantle the screw (Fig. 16/2) and remove the
spring guide.
4. Insert a large screwdriver into the channel and
turn until the pins get lose from the front plate.
5. Remove the driver blade (pos. 6, exploded draw-
ing on page 53).
6. Replace defective parts and replace it.
7. Assemble in reverse order. Please note that the
bevel at the driver blade must be turned to the
rear against the staples rail
8. Assemble the stapling head to the machine (7.6).
9. Adjust the stapling head as described (7.5)
Fig. 16
1
2
2
1
1
1
1
