20
OPERATION
LIGHTING INSTRUCTIONS
THERMOSTAT GAS CONTROL
1.
STOP!
Read the safety information on the previous page.
2.
Turn off all electric power to the appliance.
3.
Turn control knob clockwise to “OFF” position
(see Fig. 16)
.
4.
Wait (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas,
STOP!
Follow “B”
in the safety information above. If you don’t smell gas, go to
the next step.
5.
Turn knob counterclockwise to the “PILOT” position.
(see Fig. 17)
. Depress control knob.
6
With control knob depressed, push down on the ignitor
button until the pilot lights. The pilot is visible centered below
the burner, behind the front grill
(see Fig. 18)
.
• Do not attempt to light the pilot by hand
7.
Keep control knob depressed for (30) seconds after pilot
lights. Release control knob.
• If the control knob does not pop up when released,
stop and immediately and call your service technician
or gas supplier.
• If pilot goes out repeat steps 3 through 7. Wait (1)
minute before attempting to light pilot again. If after
several tries the pilot still goes out, turn the gas
control knob clockwise to the “OFF” position
and call your service technician or gas supplier.
8.
Turn on all electric power to the appliance.
9.
Turn control knob counterclockwise to desired setting.
OFF
PILOT
1
2
3
4
5
OFF
PILOT
1
2
3
4
5
Fig. 16
Fig. 17
Fig. 18: Pilot Flame Location
DETAIL A
DETAIL B
