ATTENTION: Install in accordance with national and local building and electrical codes
.
!
Page 3
9
10
12
Slide joiner bracket into power entry side of the luminaire.
Clip in Power Side of Luminaire
Listen and Feel Click
Insert Aligning Tabs
“
CLICK
”
“
CLICK
”
13
Click In Far End and Insert Aligning Tabs
12
Connect Power Wires
13
Listen For Click
Top tabs of the joiner bracket should go
between the extrusion and sheet metal cross
plate. Joiner bracket should seat fully and an
audible and tactile click should be heard.
Slide joiner aligners into bottom extrusion
detail. Ensure the small bump on the aligner
is toward the lens. *Note location of small
bump should always be on the bottom
Slide joiner bracket into far side of the next luminaire in the row. Ensure that the bracket is fully seated and clicks
into place. Slide luminaire onto aligner brackets of the previous luminaire.
Connect wiring of adjacent luminaires. Once
connected push wiring connectors at least
2” (50mm) into luminaire.
Push luminaires and together
listen for a click as the joiner
bracket is located.
