NOTE: Angle adjustment can be made before luminaire in-
stallation.
STEP 1:
After the luminaire is installed, the vertical angle of the lu-
minaire can be adjusted up or down.
STEP 2:
To adjust the angle, loosen the (2)
1/2
–
13”
X
2”
Hex bolts
located in Yoke Bracket. (Do not remove Hex Bolts.)
Loosen only enough to allow rotation.
See Fig. 2
STEP 3:
For luminaires with Photo Control, the aiming angle must
be restricted to +/
-
45° from horizontal aim.
See Fig. 3
YK—Yoke Angle Adjustment
INSTALLATION INSTRUCTIONS
PowerForm Flood (PFF)
-
YOKE MOUNT (YK)
Adjustment Bolts:
(2) 1/2
-
13”
HEX
BOLTS
Yoke Bracket
Wall Surface
45°
-
45°
0°
Fig. 2
Fig. 3
Page 3 of 4 Part 443560815060 Rev. C
Yoke Bracket
Photo Control
www.gardcolighting.com
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio
of Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not
form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
