Doc No. DCP0000615 JH 12/7/99 rev1
Operation
SigNET Amplification & Control
Tower Road,
Glover Estate,
Washington,
Tyne & Wear, NE37 2SH
Tel: +44 (0) 191 417 4551
Fax: +44 (0) 191 417 0634
Batteries
To fit the batteries, remove the rear battery com-
partment lid, and insert 2 AAA battery cells.
Alkaline or long life types are recommended for
continuous use, but the unit will function with
ordinary zinc carbon cells. If the unit is not to be
used for a long period of time, remove the batter-
ies to prevent leakage and or damage to the unit.
Headphones
The RXti 2 can be used with a wide range of
headphones designed for use with ‘walkman’
style radio/cassette recorders. These can be ‘in
ear’ types, or normal lightweight types, however
when purchasing the headphones please ensure
that the impedance stated for the units is no
greater than 32 ohms. This is normally printed on
the side of the box, or in the specification sheet.
The RXti 2 will not function properly with 600
ohm hi-fi type headphones.
Soft Start
In order to prevent large clicks or pops when
switching the unit on, we have introduced a ‘soft
start’ to the receiver. This means that when you
first turn it on the volume will be very quiet. After
a few seconds the soft start will cut out and the
unit will function at full volume. Care should be
taken not to turn the volume control up too far
initially, as the receivers volume may be too high
when the soft start function finishes.
Caution
The audio output from RXti 2 can
exceed 100mW into 8 ohms, and this
may cause hearing damage with long
term exposure. Therefore Care should
be taken not to use excessive volume
when testing loop systems.
