11
Chapter 5: DVR Setup -
5.14 Motion Set
CONT:
Continuous alarm. (Requires you press a key to stop the alarm)
OFF:
No alarm.
MOTION SET
:
AREA SET:
Press [
SEL
] button to enter the detection area of each camera.
Note: The image is divided into 16 (4*4) blocks.
Press [
REW
] and [
FWD
] to move the cursor left and right.
Press [
Up
] and [
Down
] to move the cursor up and down.
Press [
SEL
] to set add / remove the block from the detection area.
Note: Make sure the appropriate times in
Record Schedule
are set to “M” for
motion based recording to function.
SENSITIVITY:
Press [
SEL
] to adjust the sensitivity of
the motion detection on each channel
where “1” is the highest sensitivity and
“9” is the lowest.
When the sensitivity is set to “
OFF
”, the
unit will not be triggered by motion on
this channel.
MOTION RECORD TIME:
This adjusts how long recording continues
after the DVR has last been triggered by
motion.
MOTION ALARM TIME:
This adjusts how long the buzzer will
sound after the DVR has been triggered
by motion.
Note: Both values are shown in seconds.
MOTION SET
MOTION RECORD TIME: 10
MOTION ALARM TIME: OFF
MOTION SET
(UP, DOWN) MOVE (SELECT) CHANGE
PRESS (MENU) TO EXIT
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4
CHANNEL 2 SENSITIVITY 4
CHANNEL 3 SENSITIVITY 4
CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
(UP, DOWN) MOVE (SELECT) CHANGE
PRESS (MENU) TO EXIT
