Installation
Unpacking
Upon receipt of shipment, please inspect for any damage incurred in transit. If damage is
found, please notify your local representative and the transport company immediately. State date, nature of
damage and whether any damage was noticed on the shipping container prior to unpacking. Please give the
waybill number of the shipping order.
The unit should not be placed in areas;
1
with poor ventilation
2
exposed to direct sunlight
3
with high ambient temperature or adjacent to heat generating equipment
4
with high humidity or dust levels
5
susceptible to vibration
Operation
The 1ZPR has been designed to offer a simple microphone input to the network, with the choice of either local
operation or global all call operation. This function is selected on set up of the network system. This unit can
also be used in the SigNET LinX voice alarm systems.
The microphone console comprises of a speak bar, VU Meter, and two status indicators, one for OK and one
for fault.
In order to page, the thumb switch on the microphone or the speak bar are pressed, and if the system is able
to accept paging, the speak bar will light solid green and paging may commence.
The speak bar LED indicator will flash if there is a busy input indicating that an equal or higher priority input to
the system is in use on one of the selected zones, or that access to one of the selected zones is excluded. If
the zone selection is valid, the busy in will permit the speak bar to illuminate steadily and the announcement
can be made.
Fault monitoring
The electret microphone capsule is monitored for impedance and current absorption. Any deviation from pre-
set windows triggers the monitor circuit with the following results:
1. The OK LED is extinguished and the Fault LED illuminated.
2. The monitor circuit removes the 6K8 termination of the PTT. This puts an open circuit condition on the
PTT line, signalling a fault to external control equipment.
The audio lines are monitored by the phantom detect circuit which notifies any loss of the 15V phantom (due to
an open circuit or short circuit line) to the monitor circuit. The monitor circuit causes an open circuit condition
to be set on the PTT, signalling a fault to signalling a fault to external control equipment.
DC power operation
The 1ZPR requires a 24V DC supply which enters the unit through the six core cabling (see
page 4
).
Caution
This unit must never be directly connected into a 230V AC power supply
.
Page 2 of 4
DocNo.DCP0001372 ADS 14/11/05 rev4
