as conversion
Ŷ7DNHSUHFDXWLRQVRQWKHRSHUDWLRQVDQGDGMXVWPHQWVWREHFDUULHGRXWZKHQ
FRQYHUWLQJIURPRQHJDVWRDQRWKHU
Ŷ$OOZRUNPXVWEHFDUULHGRXWE\DTXDOL¿HGWHFKQLFLDQ
Ŷ%HIRUH\RXEHJLQWXUQRIIWKHJDVDQGHOHFWULFLW\VXSSO\WRWKHDSSOLDQFH
&KDQJHWKHLQMHFWRURIWKHEXUQHUV
1
2
Injector
Control handle
Tap
Sealing ring
Ŷ'RQRWGLVPDQWOHWKHWDSVKDIW
Ŷ%HIRUHSODFLQJWKHEXUQHUV
QRWEORFNHG
Ŷ$IXOORSHUDWLRQDOWHVWDQGDWHVW
VXFKDVVRDSZDWHURUJDV
DTXDOL¿HGWHFKQLFLDQRULQVWDOOHU
KDVWRPDUN³9´
RQWKHULJKWJDV
FDWHJRU\WRPDWFKZLWKWKH
LQUDWLQJSODWH
5HPRYHWKHSUHYLRXV
VHWWLQJ³9´PDUN
LQWKHHYHQWRIDPDOIXQFWLRQ
FKDQJHWKHZKROHWDS
EDFNRQWKHWRSSODFHPDNHVXUH
WKDWWKHLQMHFWRULV
IRUSRVVLEOHOHDNDJHVPXVWEH
FDUULHGRXWDIWHUJDVFRQYHUVLRQ
Ŷ$IWHUFRPSOHWLQJFRQYHUVLRQ
VHWWLQJ
GHWHFWRU
Tuurn the taps down to minimum
R
Remove the knob from the tap and place a small
‐
‐
‐
turning
does then remove the control knob and make further
from maximum flow to minimum flow. If it
Adjustmen
nt of minimum le
evel of the flame
e
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
/
must be tightly screwed in.
For butane propane gas, the adjusting screw
Refit the control knob.
ake sure that the flame does not go out by quickly
M
adjustments
to
the
gas
flow,
testing
it
again
once
the
adjustment
has
been
made.
Repeat
this
process
for
each
one
of
the
gas
taps.
Remove the pan support, Burner lid and Flame spreader.
Unscrew the injector using a 7mm box spanner and
replace it with the stipulated injector for new gas supply.
Carefully reassemble the all components.
After injectors are replaced, it is advisable to strongly
tighten
G
EN-17
