SIGNATURE 5
ecosystoves.co.uk
+ 44 1256 830099
6
ASSEMBLY
Your stove is fully built and almost ready to go. All you need to do is attach the flue collar that is boxed inside the fire, marked
“Chimney”.
FLUE PIPE ON TOP
If you are attaching the flue to the top of the stove, you will need to remove the blanking plate that is currently on top. To do this you
will need a Philips screwdriver and 10mm spanner. You can access the nuts holding the blanking plate on through the stove’s r
ear flue
outlet that will currently be open. Place the spanner on each 10mm nut as you unscrew from above. When the nuts have been removed
the blanking plate will come off. You can then attach the flue collar on top with the bolts going down into the stove.
Reaching through the rear flue, place a washer and then nut on each thread and screw from above, whilst holding the nut with the
10mm spanner. When the collar is on you can then fix the blanking plate that came off the top onto the rear. Place the bolts through the
rear blanking plate and line each one up with the pre-drilled hole on the stove. Reaching through the top outlet this time, place each
washer and nut on. When they are all in place, begin to tighten each one with the screwdriver, whilst holding the nut in place with the
10mm spanner.
FLUE PIPE AT REAR
If you are attaching a flue pipe to the rear, the blanking plate will remain on top and the flue collar will simply bolt onto the rear with
provided fittings and via the same method as above. The baffle does not need removing to fit the flue outlet in place.
Your stove is now assembled and ready for fitting!
