-
2
5
-
5. CLEANING AND MAINTENANCE
Changing and cleaning the anti-grease filters
● Removing the filters as the instruction in Pic.
10
● You can clean the filter as below measure:
1. Soak them for about 3 minute in hot water (40-50 degrees) with
a grease-loosening detergent then brush it gently with a soft
brush. Please do not apply too much pressure, avoid dam
aging it.
2. It can be put into a dishwasher with detergent, set the
temperature at around 60 degrees.
Change the lamp
1.
Switch the unit off and pull out the plug first
.
2.
Wait until the light bulb is cooled down before replacement.
3
.
Take out the aluminium filter and screw out the bulb from the inside
of the cooker hood.
4
.
Replace with same type of bulb (base
1.5
W Max).
Installing the charcoal filter (see Pic.
11
)
1. Remove the filters see Pic.
10
2. The charcoal filters (Pic.
11
) are located at both end of the motor.
Turn the charcoal filters until they are unscrewed.
3. Apply reverse procedure to uninstall the charcoal filter
.
Warning: the charcoal filer cannot be washed or recycled.
It should be replaced after approximately 120 hours of use.
● Please do not use abrasive detergent for it will damage the hood.
● Make sure that the hood is shut off before cleaning.
5.
ILCOS D code for this lamp is:
DSR-1.5/65-S-64
– L
ED modules, self- ballasted – round lamp
– Max wattage:
1.5
W
– V
oltage range:
DC 12V
– Dimensions:64 mm