27
ENGLISH
Installing Door Panels
Typical panel dimensions are based on an 84" (213.4
cm) finished height with 1/8" (3.2 mm) reveals. Template
placement must be adjusted for panels exceeding typical
dimensions.
The door panels should be installed first, followed by the
upper then lower drawer panel, if needed.
1. Place the door panel face down on a protected
surface.
2. Locate the correct side of the door panel template for
your product and position the template flush with the
top and left sides of the panel.
3. Use the template to mark the correct screw locations
on the back of the panel.
4. Slide the template to the right so it is flush with the top
and right sides of the panel.
5. Use the template to mark the correct screw locations
on the back of the panel.
6. Begin inserting a #8 x 1/2" screw into the fifth hole from
the top on each side. Stop when the screws are 3/16"
(4 mm) proud of the panel. These will be the
support screws during the panel installation.
7. Insert the support screws in the slotted holes on the
appliance door mounting brackets so that the panel is
hanging on the door.
CAUTION
Beware of pinch points when installing door panels or opening
and closing doors.
A+1/8”
A
BACK OF
DOOR PANEL
4X12 20 ea
TOP / BOTTOM DOOR PANEL
BACK OF
DOOR PANEL
BACK OF
DOOR PANEL
BACK OF
DOOR PANEL
Top / Bottom of
DOOR PANEL
84" APPLICATION
83 7/8" ACTUAL
A+1/8”
A
BACK OF
DOOR PANEL
4X12 20 ea
TOP / BOTTOM DOOR PANEL
BACK OF
DOOR PANEL
BACK OF
DOOR PANEL
BACK OF
DOOR PANEL
Top / Bottom of
DOOR PANEL
84" APPLICATION
83 7/8" ACTUAL
Mounting door panel
C
