22
B
Aligning and Leveling the Appliance
DEPTH ADJUSTMENT
Adjust the depth of the unit in the enclosure so the door
panels will fit flush with the surrounding cabinetry. Use
the gauge tool provided for a precise fit.
1. Measure the thickness of your decorative door
panels using the gauge tool.
Set the door panel on a flat, protected surface and
place the gauge tool next to the panel. Mark the notch
on the gauge tool that matches the thickness of the
door panel.
2. Use the mark on the gauge tool to adjust the depth
of the appliance in the enclosure.
Place the gauge tool against the closed door of the
appliance at the side of the enclosure. The marked
notch on the gauge tool should align with the front
edge of the enclosure.
HEIGHT ADJUSTMENT
Use the front and back leveling legs to raise the appli-
ance until the top front is 1/2" from the top of the enclo-
sure.
The front and rear leveling legs can both be adjusted
from the front.
Front: Use 5/16" (8 mm) Philips driver with flexible shaft.
Rear: Use 5/16" (8 mm) Philips driver with flexible shaft.
Gauge tool
FRONT OF
UNIT
a
Rear adjustment
Rear adjustment
Front adjustment
Front adjustment
CABINETRY
FACE
FRAME
b Gauge
a Edge
Gauge tool
FRONT OF
UNIT
a
Rear adjustment
Rear adjustment
Front adjustment
Front adjustment
CABINETRY
FACE
FRAME
b Gauge
a Edge
Gauge tool
FRONT OF
UNIT
a
Rear adjustment
Rear adjustment
Front adjustment
Front adjustment
CABINETRY
FACE
FRAME
b Gauge
a Edge
Measure panel thickness
Align depth of unit
