2
Victorian Door Knob & Plate Set Installation Instructions
PASSAGE SET INSTALLATION
1. Remove the set screws on the door knobs (
B
) with the Allen
wrench provided (
C
) to disconnect the knobs.
2. Insert the latch bolt (
E
) into the side of the door.
Note
: If the attached faceplate is not flush with the door,
carefully chisel out (mortise) some of the door.
3. Drill pilot holes (if necessary) and secure the latch bolt (
E
)
and faceplate (
F
) to the door with two wood screws (
H
).
4. Push the latch bolt in, and insert the passage spindle (
I
)
through the door.
5. Thread the decorative escutcheon (
A
) onto the spindle and
attach to the door.
6. Thread the door knob (
B
) onto the spindle.
7. Place a set screw in the set screw hole on the side of the
door knob. Use the provided Allen wrench (
C
) to secure.
8. To install the strike plate (
G
), mark the end of the bolt with
lipstick or paint. Close the door, and turn the handle
several times to mark the door frame.
Note
: If the strike plate is not flush with the door, carefully
chisel out (mortise) some of the door.
9. Secure the strike plate to the door frame with the remaining
wood screws.
A
I
H
F
E
D
C
B
G
