BURWELL BIDET TOILET SEAT INSTALLATION
INSTALLATION
Mounting Bracket Installation (Fig.1):
1. Insert the anchors into the toilet’s seat mounting
holes.
2. Place the mounting bracket over the mounting
holes,
3. Secure the mounting bracket to the toilet using the
provided clamps, rubber washers, and screws, as
shown. Tighten using a screwdriver.
NOTE: Use the paper template to determine proper
positioning of the mounting plate.
Seat Installation (Fig. 2):
1. Place the seat onto the toilet bowl.
2. Slide the seat onto the mounting bracket, as shown.
NOTE: If the seat will not fasten to the mounting
bracket, the bracket may need to be adusted. Loosen
the screws and adjust as needed.
Hose Installation (Fig. 3):
1. Connect the three-way valve to toilet’s main shutoff
valve.
2. Connect the seat to the side outlet on the
three-way valve, using the provided hose.
3. Use the top outlet of the three-way valve to
connect your toilet tank to the water supply, using a
second hose.
4. Ensure that the water supply hose and power cord
are fed through the proper holes, as shown.
NOTE: Apply plumber’s tape or thread sealant to each
threaded connection.
2
Burwell Bidet Toilet Seat Installation Instructions
Connect with
smart unit
water inlet
3-way valve
Water
supply hose
Power line hole
Water supply hole
Bolt
Washer
Clamp
Mounting bracket
Anchor
Paper template